I have an office workstation with 4 display devices connected to it, 3 24" displays, and 1 55" LED TV.

I have set 2 different display profiles, one that has the 3 24" display monitors enabled with the TV disabled (PROFILE A), and another profile where all 4 displays are enabled (PROFILE B). I only use the TV for presenting to people in my office.

I noticed that every time I am using PROFILE A and then switch to PROFILE B, the 24" monitors that is adjacent (in the display profile) to the TV, all if its contents are bumped onto the TV display and it's annoying.

I understand if I switch FROM PROFILE B to PROFILE A, I am essentially eliminating a display thus any contents on the TV will end up getting thrown onto another active display, however if I am enabling an additional display, why should Display Fusion dump all the windows from one of my displays over to the TV? I just want a blank display. I used to use UltraMon and had the same setup and this never happened to me.

This is annoying and want a solution.

I know this is old and been so buy I totally forgot I opened this thread but the same frustration has caused me to come back to these forums where I found out I have this thread open.

I'm going to enable the logging and get back to you so hopefully you can see where the problem is. It appears however the version of DisplayFusion I'm using does not have a "Important Only" logging option. I do have L0 through to L3 logging options. Which one do you want me to pick?