Displayfusion worked properly at first, but now won't disable my television.

I start with my normal setup of six monitors, and the TV disabled

If I run my "TV Only" profile it disconnects all the monitors as it should.

Going back to the "Monitors" profile, the TV isn't disabled but instead remains the primary monitor and is placed below my monitors.

I have the same issue, not being able to disable monitors
using Win 11 all up to date and Display Fusion 11.1.1
I downloaded and installed DisplayFusionSetup-11.2-Beta2-TEST11.exe
All working OK, I can disable/enable monitors and save profiles
I will be using that beta version for now until the 11.2 is released
(will advice of any issues)

I think hotkeys to set the profiles dont work
Shift+Ctrl+2 (2 is the number of monitors )
and this CLI calls dont work
"C:/Program Files/DisplayFusion/DisplayFusionCommand.exe -closeall"
"C:/Program Files/DisplayFusion/DisplayFusionCommand.exe -windowmonitorconfig"

In case it helps, it seems that after creating the profiles for my 2 multimonitor states
A) 5 monitors or B) 2 monitors (or whatever you as a user like)
instead of using the DisplayFusion hotkeys to activate the profile, if I power down (as in unplug the main power to the monitor) and only power the monitors of one state DisplayFusion detects the state and applies the profile
This has the added small power saving and can use a home automation swtch to do it from anywhere
e.g. I power down some monitors an leave only a projector pluged to the PC from home theater