When switching to a monitor profile including a monitor that is currently turned off, an error dialog will popup saying that the monitor configuration could not be applied. If the monitor is turned on, the monitor will become active and it will appear as if switching to the monitor profile did work correctly. However, if the error dialog is closed, the initial monitor profile will be switched back to.
Is there a way to ignore the error in such a case, since I've seemingly fixed the situation after the error has occurred?
Steps to reproduce
1. Create two monitor profiles, profile A with monitor 1, and profile B with monitor 2 and monitor 3
2. Turn on monitors 1 and 2, turn off monitor 3
3. Switch to monitor profile A
4. Switch to monitor profile B
5. Turn on monitor 3
6. Observe that error dialog pops up, and that only monitors 2 and 3 are active
7. Close the error dialog
8. Observe that only monitor 1 is active
I would wish that after the seventh step, only monitors 2 and 3 are active, i.e. that the monitor profile B would be active.
The contents of the error dialog (also seen in the attached screenshot):
An error has occurred while applying your new Monitor configuration. Please check your settings and try again.
Would you like to view the help guide for troubleshooting tips?
Error: Failed to call SetDisplayConfig. [HR: ERROR_INVALID_PARAMETER]
[System.Exception]
DisplayFusion Pro 10.1.2
Windows 11 Pro
Version 23H2 (OS Build 22631.4460)
EDIT: Fixed by updating DisplayFusion Pro to version 11.0.1