Hey there! I recently started using a Portrait mode monitor next to my ultra wide monitor. Question I have is, when using the middle click button to move windows around, can I ignore my portrait monitor exclude it from moving.
If you open up the DisplayFusion Advanced Settings window, we have a setting called "Ignore Monitors". You can add the monitor ID you want ignored there, and it should skip it when using that function.
If you open up the DisplayFusion Advanced Settings window, we have a setting called "Ignore Monitors". You can add the monitor ID you want ignored there, and it should skip it when using that function.
Hope that helps!
This is EXACTLY what I needed, works perfectly, thank you!!
Hi, It does not work for me. I have two monitor and I would like to ignore 1. monitor from the 'Move to Next Monitor' list.
I set the Ignore monitor to 1 in Advanced options.
You can check my attached config.
Thanks for sending that over. Your monitor ID is actually set to 1.1 because you have splits enabled. If you set that advanced setting to ignore monitor "101" it should work. You'll use a 0 instead of a decimal when entering it into the settings window.
Thanks for sending that over. Your monitor ID is actually set to 1.1 because you have splits enabled. If you set that advanced setting to ignore monitor "101" it should work. You'll use a 0 instead of a decimal when entering it into the settings window.
Thanks!
Works fine! Thanx!
Can I ingore more than one monitor?
