Alex Waterland63787
2 discussion posts
I've got 2 different PCs connected to 2 monitors via a KVM switch. When PC1's monitor profile is detected it runs a trigger than connect my bluetooth speakers to PC1. When I switch to PC2 I run the same trigger to connect my bluetooth speakers but since the speakers are already connected to PC1 they won't connect to PC2.
I have a script to disconnect the speakers from PC1 but I can't figure out how to get Display Fusion to run it when it detects that no monitors are connected to PC1. Is there some sort of monitor profile I can set up that detects no monitors are connected to run the trigger?
Hi Alex,
Unfortunately I don't think this is possible, but you can try the below to see if it works:
1) Create a trigger using the "Monitor Profile Changed" event, but don't specify a monitor profile with it, and have the trigger run the disconnect script.
2) Move the trigger for connecting, above the trigger created in #1, and make sure "Stop processing triggers if this one matches" is enabled.
Thanks!
Mar 8, 2022 (modified Mar 8, 2022)
•
#2
Alex Waterland63787
2 discussion posts
Thank you for the response. I'm unable to check the 'Stop processing triggers if this one matches' box, it's grayed out.
• Attachment [protected]: Stop processing.png [28,787 bytes]
• Attachment [protected]: Triggers.png [8,966 bytes]
