Hi I’m new to Displayfusion and |I’m struggling with setting up profiles and loading profiles, let me first explain what I am trying to do

I have a single PC that I use for a gaming rig and also for my work PC

Desk - I have 2 monitors on my desk a 32” (2560x1440) and 24” (1920x12080) and I use these together
Rig - I have 4 monitors on my gaming rig 3x39” (3440X1440) & a 27” (2560x144).

The 27” and 24” monitors run through single HDMI connection and a switch to switch between them
The 39” are connected via display port and the 32” via HDMI
PC is a I9 with a 4090 (3xDP & 2xHDMI) so can run the monitors

I will only want to use either the rig or the desk at any one time
I have to use NVidia Control Panel and surround to create a single monitor on the rig (rather than using 3 separate monitors) so that has the resolution of 10320x1440

Thus I wanted to effectively have two profiles one for the rig and one for the desk be able to swap between the 2 profiles and assign this to a button on streamdeck

However here’s what’s happening :

When I turn the pc on with the rig connected and select rig profile (which I have saved the last time it was working) I get a single 39” screen and the 27” screen. I have to then enable the two other 39” screen and they are separate and thus I have to re-run surround to re-setup
If I restart after I have set up with surround and the rig turned on then all is fine, but it seems to be swapping between the two setups that is causing the problems

Am I asking to much from Displayfusion / surround or has my lack of technical ability kicked in
Any help would much be appreciated
Thanks